Quick guide for .rpm and .deb packages to install CloudBees Jenkins Enterprise on a new instance.
Download/Installation of the official CJOC/CJE releases
All the CJE releases can be found on the link below.
CloudBees creates different packages for each platform:
Inside each section it is explained how to proceed with the installation.
Operative System configuration: Dedicated users for running the Jenkins process
By default, after installing a
.rpm or a
.deb package the
jenkins:jenkins (user:group) is created. You can verify the ids created with the commands below:
id -u jenkins id -g jenkins
If a shared folder is used as a location of the
JENKINS_HOMEthe same user:group
jenkins:jenkinsneeds to exist on this machine. You can add do this on the way below:
Create the “jenkins” user:
sudo useradd jenkins sudo usermod u [jenkins’ UID goes here] jenkins
Create the “jenkins” group:
sudo groupadd jenkins sudo groupmod g (jenkins’ GID goes here] jenkins
In case you have changed the default
jenkins:jenkins, you will need to
chownthe following paths:
$JENKINS_HOME. Some OS admins doesn’t allow by default that a different user than
rootcan access to those paths, so you might need to change the permissions on those paths.
It is always a bad practice to use the
rootuser as owner of the jenkins process.
Initial configuration of Jenkins
The Jenkins configuration file is used for doing some Jenkins configurations like modifying the
JENKINS_HOME or adding some
JAVA_ARGS to customize Jenkins.
The Jenkins configuration file
The location of the Jenkins configuration file for a
.rmp and a
.deb installation can be found in:
/etc/default/jenkins: location for most of the Linux distributions.
/etc/sysconfig/jenkins: location for RedHat/CentOS distribution.
Initial memory configuration
The initial setup of Jenkins is not configured in terms of
Xmx. The initial recommended configuration is
-Xmx2048m. Notice that from these values you should monitor the heap memory used by Jenkins keeping in mind that that when Jenkins is busy the heap memory should represent an usage between 60-80%. If it is bigger than 80%, you should increase the heap memory on the instance unless you are suffering a memory leak.
In case of a RedHat/CentOS installation you will need to customize this in the
jenkins.conf under the section
JENKINS_JAVA_OPTIONS. For other distributions the section is called
More information about how to add Java arguments to Jenkins can be found on this KB article
Start the Jenkins service
You just need to go to run
sudo service jenkins start. CJE should be accessible on https://localhost:8080/ by default.
You can verify on
/var/log/jenkins that the instance is up and running looking for the stacktrace below
INFO: Jenkins is fully up and running
For deeper documentation, please visit our official documentation site.