This chapter provides information about the most common error messages for the Agent component of CloudBees Build Acceleration. The range for Agent error codes is 2000–2999.
| Agent errors regarding the establishment of the virtual file system for a particular build will be displayed if there are at least three errors. These errors would occur during the initial setup of the agent’s build-specific environment but before any particular build step is run on that agent. The most common type of error involves eMake roots or Cygwin mounts, where virtual file system setup is specific to the build but not to any particular build step. |
-
EC2000 [agent]: agent reports: [Error in mkdir([path]): Permission denied]
-
EC2002 An unrecognized code was seen by the agent on an eMake client connection.
-
EC2038 [agent]: agent reports: [Mount::set couldn’t open repository "./ecagent.state": [error]]
-
EC2062 [agent]: agent reports: [Error mounting filesystem (command 'mount') at "[path]": [error]
-
EC2093 Clock skew between eMake and agent is _milliseconds_ ms.
-
EC2128 The authentication offered by the eMake client is hereby rejected.
-
EC2129 The agent requires authentication for this eMake client connection.
-
EC2130 Authentication is not offered for this eMake client connection.
-
EC2131 Authentication was already performed for this eMake client connection.
-
EC2137 An agent created a temporary file but was unable to delete it.