You can add another node to an HA cluster that you have already created.
To add a node to a cluster, you need:
A host on which to install the new node
An installer that is equal in version number to the existing CloudBees CD servers
If you have hotfixes for the existing CloudBees CD servers, you must have copies of the JARs, scripts, and so on to copy into the new server.
Load balancer to add a new server entry
conffolder from the primary node
This folder must contain the files that have been uploaded to Zookeeper.
Connection and ports to ensure that the host can Telnet to the database and load balancer and that the necessary ports are open.
Also, ensure that from the load balancer, you can Telnet to the new server through the necessary ports (61613, 8000, and 8443).
Adding a Node
Use the following steps to add a node to an HA cluster. These steps might vary depending on your load balancer and whether your CloudBees CD version includes hotfixes. If you are using HAProxy, make sure you follow the steps below for adding a server target to HAProxy.
To add a node to an existing CloudBees CD cluster:
On the new machine, ensure that you have the same permissions and users as the other machines.
Complete an advanced installation of CloudBees CD without the database and web server.
Stop the CloudBees CD server service and apply all hotfixes if available.
Back up the
confdirectory by renaming the original
confdirectory located at
confdirectory from the primary node to the new node.
Restart the CloudBees CD server.
(If using HAProxy) Create an entry for the additional node (
node3in the following example) and add its server IP address to the
Haproxy.cfgfile as follows:
frontend commander-server-frontend-secure mode tcp bind 0.0.0.0:8443 ssl crt /etc/ssl/server.pem default_backend commander-server-backend
backend commander-server-backend mode http server node1 <IP Address of Initial Node>:8000 check server node2 <IP Address of Next Node>:8000 check server node3 <IP Address of Next Node>:8000 check stats enable option httpchk GET /commanderRequest/health
# load balance port 61613 across Commander servers, with HAProxy acting as the SSL endpoint frontend commander-stomp-frontend mode tcp bind 0.0.0.0:61613 ssl crt /etc/ssl/server.pem default_backend commander-stomp-backend option tcplog log global
backend commander-stomp-backend mode tcp server node1 <IP Address of Initial Node>:8000 check server node2 <IP Address of Next Node>:8000 check server node3 <IP Address of Next Node>:8000 check option tcplog log global
For details, see the KBEC-00281 - Configuring Load Balancers in CloudBees CD Clusters KB article or the HAProxy documentation at link:https://www.haproxy.org/\https://www.haproxy.org /.
(If using HAProxy) Restart HAProxy by entering:
sudo service haproxy restart sudo service haproxy status
(If using HAProxy) Check the status by browsing to
Applying Hotfixes to the New Node
If you have hotfixes, you must add them to the CloudBees CD server after you finish installing it in step 2 above. After confirming the hotfixes are in place, use the
ecconfigure command to set up the server and get the configuration files from ZooKeeper.