You can switch to the built-in (default) CloudBees CD database at any time. The following procedure shows how to switch to the built-in database from any CloudBees CD-supported alternate database.
Using the built-in database is possible only if during the installation it was activated via the --installDatabase
installer parameter or by the corresponding options in the GUI installer.
If you are using two different CloudBees CD servers in a non-HA configuration, they cannot point to the same database. |
-
If the built-in database service is disabled, enable and start it.
To do so, enter the following ecconfigure command:
ecconfigure --databaseEnableService=1
-
Point the CloudBees CD server to use the built-in database.
You can use the UI or the ectool
setDatabaseConfiguration
command. If you did not change the default values for the password (changeme
) and port (8900
), enterectool setDatabaseConfiguration --databaseType builtin --hostName localhost --userName root --databaseName eflow
If you have changed the default values (either during or after installation) for the password and port, enter
ectool setDatabaseConfiguration --databaseType builtin --hostName localhost --userName root --password <password> --port <port_number> --databaseName eflow